Front Wiper Module: Disassembly

The front wiper motor and its rubber boot are available for service replacement. Following are the procedures for disassembling these components from the front wiper module unit.

1. Remove the front wiper module from the cowl plenum. (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER MODULE - REMOVAL) .
2. Release the retainer that secures the wiper motor pigtail wire connector to the front wiper module bracket.
3. Turn the front wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft.
4. Remove the three screws that secure the wiper motor to the front wiper module mounting bracket.
5. Remove the wiper motor from the front wiper module bracket.