LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2002 >> Grand Cherokee Overland >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Diagnostic Tests >> Interior Lighting >> Dim Sw Short To Ground
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Dim Sw Short To Ground

When Monitored: Ignition in RUN and IOD fuse/connector installed.

Set Condition: The voltage of the Panel Lamps Dimmer Signal circuit has gone less than 0.3 volts for 5 seconds.

Possible Causes are:

  1. Disconnect the left multi-function switch connector. Turn ignition on. Using the DRBIII(R) in Sensors, read the Panel Lamp voltage. Is the voltage less than 4 volts? If yes, go to next step. If no, replace the left multi-function switch. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS.
  2. Turn ignition off. Disconnect the left multi-function switch connector. Disconnect the Body Control Module C1 connector. Measure the resistance of the Panel Lamps Dimmer Signal circuit to a known-good ground. Is the resistance less than 1000 ohms? If yes, repair the Panel Lamps Dimmer Signal circuit for a short to ground. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS. If no, go to next step.
  3. Turn ignition off. Disconnect the Left Multi-function switch connector. Disconnect the Body Control Module C1 connector. Measure the resistance of the Headlamp Switch Return circuit to a known-good ground. Is the resistance less than 1000 ohms? If yes, repair the Headlamp Switch Return circuit for a short to ground. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS. If no, go to next step.
  4. If there are no possible causes remaining, replace the Body Control Module. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals