LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Grand Cherokee Laredo, 4.7 N, RWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Removal & Installation >> Body Control Module >> Removal & Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal & Installation

  1. Disconnect negative battery cable. Remove instrument panel fuse cover. Reach behind junction block and disconnect Body Control Module (BCM) connectors. See Fig 1. Remove 4 Torx (T-20) screws attaching BCM to rear of junction block.
  2. Pull BCM straight out from junction block until connector is fully disengaged and clear of junction block. Remove BCM. To install, reverse removal procedure. Torque BCM retaining screws to 20 INCH lbs. (2.2 N.m).
  3. Whenever BCM is replaced, anti-theft system must be enabled by unlocking doors with key one time or by using scan tool. This allows BCM to see that the vehicle is equipped with an anti-theft system.
Fig 1: Removing Body Control Module
G99C02142Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals