Connector Identification
WARNING: This page is about a different car, the 1999 Dodge Pickup and 1999 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following terminals are shown as viewed from harness side of connector. Only connectors with 3 or more terminals (pins) are included. For circuit identification and wiring diagram, see RAM PICKUP
wiring diagram in WIRING DIAGRAMS article.
CONNECTOR IDENTIFICATION
| Connector | Illustration | |
|---|---|---|
| Accelerator Pedal Position Sensor | Fig 1 | |
| Brakelight Switch | Fig 2 | |
| Camshaft Position Sensor | ||
| BE/BR Body (Diesel) | Fig 3 | |
| BE/BR Body (Gas) | Fig 4 | |
| Controller Anti-Lock Brakes | Fig 5 | |
| Crankshaft Position Sensor | ||
| BE/BR Body (Diesel) | Fig 6 | |
| BE/BR Body (Gas) | Fig 7 | |
| Data Link Connector | Fig 8 | |
| Engine Control Module | ||
| BE/BR Body (Diesel) | Fig 9 | |
| Engine Oil Pressure Sensor | ||
| BE/BR Body (Diesel) | Fig 10 | |
| Fuel Injection Pump | ||
| BE/BR Body (Diesel) | Fig 11 | |
| Fuel Pump Module | Fig 12 | |
| Governor Pressure Sensor | Fig 13 | |
| Idle Air Control Motor | Fig 14 | |
| Ignition Coil | ||
| 3-Pin BE/BR Body (8.0L) | Fig 15 | |
| 4-Pin BE/BR Body (8.0L) | Fig 16 | |
| Leak Detection Pump | Fig 17 | |
| Manifold Absolute Pressure Sensor | ||
| BE/BR Body (Diesel) | Fig 18 | |
| BE/BR Body (8.0L) | Fig 19 | |
| Except BE/BR Body (Diesel & 8.0L) | Fig 20 | |
| Park/Neutral Position Switch | Fig 21 | |
| Powertrain Control Module | Fig 22 | |
| Throttle Position Sensor | Fig 23 | |
| Transmission Solenoid | ||
| BE/BR Body | Fig 24 | |
| Vehicle Speed Sensor | Fig 25 | |
| 1/1-1/3 Heated Oxygen Sensor (Typical) | Fig 26 | |