Test 106C - Body Control Module Battery Power Supply
WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION in this article. For appropriate wiring diagram, see WIRING DIAGRAMS section at the end of this article. Perform TEST VER-1B after each repair.
- Ensure all lamps are off. Close all doors except left front door. Hold left front door ajar switch closed. Go to next step.
- Using scan tool in ohmmeter mode, check resistance of IOD fuse connector (Pink wire). If resistance is less than 5 ohms, repair short to ground in Pink wire and replace IOD fuse. If resistance is more than 5 ohms, go to next step.
- Reconnect BCM Blue connector. Check resistance of IOD fuse connector (Pink wire). If resistance is more than 5 ohms, replace IOD fuse. If resistance is less than 5 ohms, replace BCM.