LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1995 >> Cherokee Country, 4WD, Part Time, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Speed Control Menu
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Speed Control Menu

  1. To perform cruise control system tests using DRB, DRB must be in SPEED CONTROL MENU. At SPEED CONTROL MENU, fault codes and DRB test functions can be accessed.
  2. To reach SPEED CONTROL MENU, turn ignition off. Connect DRB to engine diagnostic connector. Connector is located in engine compartment, near PCM. Turn ignition switch to RUN position.
    NOTE: DO NOT touch DRB keypad during DRB power-up sequence or an error message will result.
  3. All DRB character positions will glow and copyright information will appear on screen for a few seconds. If DRB screen is blank or any error messages appear, see G-TESTS W/CODES - BODY CONTROL COMPUTER article in ENGINE PERFORMANCE.
  4. After a few seconds DRB menu will appear. At DRB menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. DRB menu will appear indicating engine year, size, type of transmission and PCM part number.
  5. After a few seconds AIR COND menu will appear. Press "1" (WITH A/C) or press "2" (WITHOUT A/C). DRB display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "3" (SPEED CONTROL) key. Press ENTER key.
  6. Display will change to SPEED CONTROL. At SPEED CONTROL MENU, specific test functions programmed into DRB can be performed. Following DRB modes can be accessed: SYSTEM TESTS, READ FAULTS, STATE DISPLAY, ACTUATOR TESTS and ADJUSTMENTS.
scientia non olet · About LEMON Manuals