LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1994 >> Wrangler S, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Ignition System: Distributor: Installation

  1. Position distributor in engine. Ensure "O" ring is properly seated on distributor. Replace "O" ring if cracked or nicked. Carefully engage distributor driven gear with camshaft drive gear so when distributor is installed properly, rotor aligns with reference mark.
  2. Install distributor cap. Check all high tension wires for good connections. Install hold-down nut. Connect camshaft position sensor wiring harness connector.
scientia non olet · About LEMON Manuals