ZF 5HP24
- Park vehicle on level ground. Apply parking brake. Wait at least 2 minutes. Ensure transmission fluid temperature is less than 86°F (30°C). Start engine and verify idle speed is 600-750 RPM. If idle speed is not correct, repair as necessary.
- Move gear selector from Park to Drive to Reverse and back to Park. Raise and support vehicle. Remove fluid filler/level side plug. Fluid level should be level with bottom of filler plug hole and flow of fluid should be a trickle after about one minute. Top off as necessary.
- Top off using a syringe dedicated to transmission fluid only (not used for any other type of oil or fluids). Ensure transmission fluid temperature is less than 122°F (50°C). Inject transmission fluid into filler side plug until it overflows from plug opening. Wait for at least one minute until flow of fluid is reduced to a trickle.
- Install fluid filler/level side plug and tighten to specification. See TORQUE SPECIFICATIONS . Check for leaks and clean up spilled fluid.