LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2008 >> Ascender S, 4WD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information & Procedures >> DTC C0283 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

  1. Turn OFF the ignition for 5 seconds, then turn ON the ignition and wait at least 60 seconds.
    • If DTC C0283 does not reset, go to Diagnostic Aids
  2. Turn the ignition OFF. Disconnect the traction control switch harness connector. Turn the ignition ON and wait at least 60 seconds.
    • If DTC C0283 does not reset, replace the traction control switch.
    • If the DTC C0283 resets, check the TCS/mode switch signal circuit for a short to ground or replace the BCM.
scientia non olet · About LEMON Manuals