LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement (4.2L) >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

  1. Install the power steering pump pulley. Refer to Power Steering Pulley Replacement (4.2L)  or Power Steering Pulley Replacement (Except 4.2L) .
    2. Fig 1: View Of Power Steering Pump Bolts
    GM687444Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the power steering pump.
  3. Install the power steering pump mounting bolts.

    Tighten:  Tighten the power steering pump mounting bolts to 25 N.m (18 lb ft).

    4. Fig 2: Identifying Power Steering Hoses
    GM687439Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering cooler hose (2) to the power steering pump.
  5. Install the power steering pressure hose (1) to the power steering pump.

    Tighten:  Tighten the power steering pressure hose to 25 N.m (18 lb ft).

  6. Remove the drain pan from under the vehicle.
  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  9. Bleed the power steering system. Refer to Power Steering System Bleeding .
  10. Inspect the power steering system for leaks and the hoses for clearance away from the frame and other components.
scientia non olet · About LEMON Manuals