September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Manifold Absolute Pressure Sensor
Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure (vacuum). MAP sensor signal voltage to the PCM varies from below 2 volts at idle (high vacuum) to above 4 volts with ignition on, engine not running or at wide-open throttle (low vacuum). MAP sensor is used to determine following:
- Manifold pressure changes while linear EGR flow test diagnostic is being run.
- Barometric pressure (BARO).
If PCM detects a voltage that is lower than the possible range of the MAP sensor, DTC P0107 will be set. A signal voltage higher than the possible range of the sensor will set DTC P0108. An intermittent low or high voltage will set DTC P1107. PCM can detect a shifted MAP sensor. PCM compares MAP sensor signal to a calculated MAP based on throttle position and various engine load factors. If PCM detects a MAP signal that varies excessively above or below calculated value, DTC P0106 will set.