September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Test B-1: Abs Warning Light Does Not Illuminate (Key On/Engine Off)
- Check METER fuse (15-amp) located in interior fuse block. If fuse is open, replace fuse. After repairs, go to step 5. If fuse is okay, go to next step.
- Check ABS warning light. If bulb is open, replace bulb. After repairs, go to step 5. If bulb is okay, go to next step.
- Turn ignition off. Disconnect EHCU harness connectors. Turn ignition on. Measure voltage between EHCU harness connector terminals No. 6 (Violet/White wire) and No. 7 (Black wire). If battery voltage is present, go to next step. If battery voltage is not present, repair harness and connector as necessary. After repairs, go to step 5.
- Check for continuity between chassis ground and EHCU harness connector terminals No. 2 and 7 (Black wires). If continuity is present, harness connection or EHCU is faulty. If continuity is not present, repair harness as necessary. After repairs, go to next step.
- Reconnect all components. Ensure all component are properly installed. Verify system operation. See SYSTEM OPERATION CHECK under TROUBLE SHOOTING.