LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 1992 >> Stylus S, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crank Angle Sensor >> Removal & Installation (3.2L - DIS)
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal & Installation (3.2L - DIS)

  1. Remove negative battery cable. Remove right side exhaust shield. Disconnect front drive shaft yoke. Remove crank angle sensor wiring connector located on right side of block, behind motor mount. See Fig 1. Remove sensor mounting nut and sensor.
  2. To install, reverse removal procedure. Tighten nut and bolts to specification. See TORQUE SPECIFICATIONS  at end of article.
Fig 1: Removing Crank Angle Sensor (3.2L)
G92I25310Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals