YAW RATE/SIDE/DECEL G SENSOR : Removal and Installation

REMOVAL

CAUTION:

Never drop or strike yaw rate/side/decel G sensor, because it has little endurance to impact. Never use a pneumatic tool.

Remove console finisher assembly. Refer to CENTER CONSOLE ASSEMBLY : Removal and Installation .
Disconnect yaw rate/side/decel G sensor harness connector.
Remove yaw rate/side/decel G sensor.

INSTALLATION

Note the following, and install in the reverse order of removal.

Never drop or strike yaw rate/transverse/decel G sensor, because it has little endurance to impact. Never use a power tool.
Perform decel G sensor calibration when yaw rate/side/decel G sensor is removing/installing or replaced. Refer to Work Procedure .