Component Function Check

1. 1. Start engine and warm it up to normal operating temperature.
   2. Turn A/C switch and blower fan switch ON.
   3. Check the voltage between ECM harness connector terminals as per the following.

      ECM				Condition	Voltage
      +		-
      Connector	Terminal	Connector	Terminal
      F79	108 (Refrigerant pressure sensor signal)	F79	125	[Engine is running] Warm-up condition Idle speed Both A/C switch and blower fan motor switch: ON (Compressor operates)	1.0 - 4.0 V

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Proceed to Diagnosis Procedure .