With Intelligent Key System
WARNING: This page is about a different car, the 2022 Nissan Rogue Sport. However, it is still accessible from the selected car via links, so may be relevant.
Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*.
*: New one means a virgin ECM that has never been energized on-board.
(In this step, initialization procedure using CONSULT is not necessary)
CAUTION:
When replacing the ECM, always replace it with a new one. The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another vehicle.
NOTE:
- If multiple keys are attached to the key holder, separate them before beginning work.
- Distinguish keys with unregistered key IDs from those with registered IDs.
- PERFORM ECM RECOMMUNICATING FUNCTION
- Install ECM.
- Contact backside of the registered Intelligent Key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
- Maintain ignition switch in the ON position for at least 5 seconds.
- Turn ignition switch OFF.
- Check that the engine starts.
GO TO 2.
- PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform the following procedure.
Refer to Work Procedure .
END