LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> JX35 AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Unit Removal And Installation >> Transfer Assembly >> Removal and Installation >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal and Installation: Removal

  1. Drain the transfer oil. Refer to "DRAINING ".
  2. Remove rear propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove front drive shaft (RH). Refer to "REMOVAL AND INSTALLATION (RH) ".
    CAUTION: Be careful not to damage gear ring oil seal inside of transfer.
  4. Remove exhaust manifold (RH). Refer to "REMOVAL AND INSTALLATION (RH) ".
    CAUTION: Handle carefully to avoid any shock to three way catalyst.
  5. Support transaxle with a suitable jack.
  6. Remove the steering gear. Refer to "REMOVAL AND INSTALLATION - AWD ".
  7. Remove rear gusset and transfer gusset.
  8. Remove transaxle assembly to transfer assembly bolts.
    CAUTION: Be careful not to damage gear ring oil seal inside of CVT.
    Bolt No. 1 2
    Quantity 4 2
    Bolt length "l  " mm (in) 65 (2.56) 40 (1.57)
    Fig 1: Identifying Transaxle To Transfer And Transfer To Transaxle Mounting Bolts
    G04921268Courtesy of NISSAN NORTH AMERICA, INC.
  9. Remove transfer assembly from the vehicle.
    CAUTION:
    • Do not damage air breather hose.
    • After removing transfer from transaxle, always replace differential side oil seal of the transaxle side with new one. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals