Required Tools

ICC alignment kit 1-20-2721-1-IF in addition to one of the following:
1. Hunter self-centering wheel adapter (Hunter wheel alignment tool)
2. Special Service Tool kit 1-20-2722-1-IF (kit SCA W/Tire Clamp-ICC Aiming)
The following ICC alignment kit 1-20-2721-1-IF is necessary to perform the ICC sensor alignment:
ICC target board.
- Position 1, with top tilted 2° toward vehicle (1).
- Position 2, vertical (2).
- Position 3, with top tilted 2° away from vehicle (3).
  
  Fig 1: Identifying ICC Target Board Positions
  Courtesy of NISSAN NORTH AMERICA, INC.
Hunter self-centering wheel adapter (1) [shown with laser assembly (2) installed] (Hunter alignment rack head may be substituted).
NOTE: Retailers that are not equipped with a Hunter self-centering wheel adapter will require the following kit:
Part No. 1-20-2722-1-IF (kit SCA W/Tire Clamp-ICC Aiming)

Fig 2: Identifying Self-Centering Wheel Adapter And Laser Assembly
Courtesy of NISSAN NORTH AMERICA, INC.
Laser assembly (with bi-directional laser beam) as shown in the illustration below.
- Tightening knob (1)
- Power ON/OFF button (2)
- Front laser beam opening (3)
- Rear laser beam opening (4)
- Attaching shaft (5)
  
  Fig 3: Identifying Laser Assembly Tightening Knob, Power ON/OFF Button, Front And Rear Laser Beam Opening And Attaching Shaft
  Courtesy of NISSAN NORTH AMERICA, INC.
Stationary target as shown in the illustration below.
- Stationary target (1)
- Laser signal reception plate (2)
  
  Fig 4: Identifying Stationary Target And Laser Signal Reception Plate
  Courtesy of NISSAN NORTH AMERICA, INC.
Distance chain (not shown).