LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Engine Control System - DTCS P0130 Through P0445) >> DTC P0181: FTT Sensor >> Component Function Check
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Function Check

WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUEL TANK TEMPERATURE SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
    3. Remove fuel level sensor unit. Refer to "EXPLODED VIEW ".
    4. Check resistance between "fuel level sensor unit and fuel pump" terminals by heating with hot water as shown in the figure.
    RESISTANCE SPECIFICATION

    Terminals Condition Resistance (kΩ)
    4 and 5 Temperature [°C (°F)] 20 (68) 2.3 - 2.7
    50 (122) 0.79 - 0.90
    Fig 1: Checking Fuel Tank Temperature Sensor
    G07165033Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

  2. CHECK INTERMITTENT INCIDENT

    Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals