LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> EX35 Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Unit Removal And Installation >> Transmission Assembly >> AWD >> AWD: Removal and Installation >> Removal
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

AWD: Removal and Installation: Removal

CAUTION:
  • When removing the A/T assembly from engine, first remove the crankshaft position sensor (POS) from the A/T assembly.
  • Be careful not to damage sensor edge.
  1. Shift the selector lever to "P" position, and then release the parking brake.
  2. Disconnect the battery cable from the negative terminal.
  3. Remove control rod from A/T shift selector assembly. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove propeller shaft assembly (rear). Refer to "REMOVAL AND INSTALLATION ".
  5. Remove propeller shaft assembly (front). Refer to "REMOVAL AND INSTALLATION ".
  6. Remove manual lever from A/T assembly. Refer to "REMOVAL AND INSTALLATION ".
  7. Support A/T assembly with a transmission jack.
    CAUTION: When setting the transmission jack, be careful not to allow it to collide against the drain plug and overflow plug.
  8. Remove crankshaft position sensor (POS) from A/T assembly. Refer to "DISASSEMBLY AND ASSEMBLY ".
    CAUTION:
    • Never subject it to impact by dropping or hitting it.
    • Never disassemble.
    • Never allow metal filings, etc. to get on the sensor's front edge magnetic area.
    • Never place in an area affected by magnetism.
  9. Remove starter motor. Refer to "REMOVAL AND INSTALLATION ".
  10. Remove rear plate cover. Refer to "REMOVAL AND INSTALLATION ".
  11. Turn crankshaft, and remove the four tightening bolts for drive plate and torque converter.
    CAUTION: When turning the crankshaft, turn it clockwise as viewed from the front of the engine.
  12. Remove A/T fluid cooler tubes. Refer to "AWD: REMOVAL AND INSTALLATION ".
  13. Plug up openings such as the A/T fluid cooler tube hole.
  14. Disconnect A/T assembly harness connector and AWD solenoid harness connector.
  15. Remove harness and brackets.
  16. Remove bolts fixing A/T assembly to engine with a power tool.
  17. Remove air breather hose. Refer to "AWD: REMOVAL AND INSTALLATION ".
  18. Remove A/T assembly with transfer assembly from vehicle.
    CAUTION:
    • Secure torque converter to prevent it from dropping.
    • Secure A/T assembly to a transmission jack.
  19. Remove transfer assembly from A/T assembly with a power tool. Refer to "UNIT REMOVAL AND INSTALLATION ".
Fig 1: Holding A/T Assembly On Transmission Jack
G04901164Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals