Work Procedure

WARNING: This page is about a different car, the 2011 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION
CONSULT-III Configuration

Select "CONFIGURATION" of CAN gateway.

When writing saved data: Go to 2.

When writing manually: Go to 3.
PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration

Perform "WRITE CONFIGURATION - Config file".

WORK END
PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Select "SETTING".
3. When "COMMAND FINISHED", select "End".
  Go to 4.
CHECK "SELF DIAGNOSTIC RESULT"
1. Erase all ECU self-diagnosis results using CONSULT-III.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Perform "All DTC Reading" using CONSULT-III.
5. Check that all ECU self-diagnosis results have no DTC of CAN communication.
  NOTE:
  DTCs of CAN communication are as follows:
  - U0101
  - U0140
  - U0164
  - U1000
  - U1001
  - U1507
  - U1508
  WORK END