Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

To install the slide plate (1), create clearance (L) in the steering column assembly mounting area (2) as follows.
L: 2.0 mm (0.079 in)

Fig 1: Identifying Clearance In Steering Column Assembly Mounting Area
Courtesy of NISSAN NORTH AMERICA, INC.
Tighten the mounting bolts and nuts in the order shown in the figure below when installing the steering column assembly.
Be careful of the following points when installing the steering column assembly.

Fig 2: Steering Column Assembly Mounting Bolt Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Never give axial impact to steering column assembly during installation.
- Never move steering gear assembly.
- Never reuse the joint mounting nut (lower shaft side).
Perform inspection after installation. Refer to "INSPECTION AND ADJUSTMENT ".