DTC Confirmation Procedure

1. PRECONDITIONING

   If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

   GO TO 2.

2. CHECK DTC DETECTION

With CONSULT 

1. Turn ignition switch ON.
2. Select "SLCT LVR POSI" and "MANU MODE SW" in "Data Monitor" in "TRANSMISSION".
3. Maintain the following each conditions more than 2 seconds.

   SLCT LVR POSI : D

   MANU MODE SW : ON

4. Perform "Self Diagnostic Results" in "TRANSMISSION".

   Is "P1815" detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END