September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Stop Lamp Switch
- Turn ignition switch OFF.
- Disconnect stop lamp switch harness connector.
- Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
CONTINUITY REFERENCE CHART
| Condition |
Continuity |
| Brake pedal: Fully released |
Should not exist |
| Brake pedal: Slightly depressed |
Should exist |
- If NG, adjust stop lamp switch installation, refer to
"INSPECTION AND ADJUSTMENT
", and perform step 3 again.
Courtesy of NISSAN MOTOR CO., U.S.A.