LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2009 >> EX35 Base, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> On-Vehicle Repair >> Power Steering Oil Pump >> Disassembly and Assembly >> Disassembly
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Disassembly and Assembly: Disassembly

  1. Remove rear cover mounting bolts, and then remove rear cover from body assembly.
    CAUTION:
    • Fix oil pump with a vise if necessary.
    • Use copper plates when fixing with a vise.
  2. Remove O-ring from body assembly.
  3. Remove rear side plate from cartridge, and then remove Teflon ring and O-ring from rear side plate.
  4. Remove rotor snap ring using a snap ring pliers, and remove pulley from body assembly.
    CAUTION: Remove pulley so as not to be damaged when removing rotor snap ring.
    Fig 1: Identifying Rotor Snap Ring With Snap Ring Pliers
    G04876921Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove cartridge and front side plate.
  6. Remove flow control valve A (1), flow control valve spring (2) and flow control valve B assembly (3) from body assembly (4).
    CAUTION: Never drop and damage flow control valve A and flow control valve B assembly when removing.
  7. Remove oil seal from body assembly.
  8. Remove mounting bolt of suction pipe, and then remove suction pipe from body assembly.
  9. Remove O-ring from body assembly.
  10. Remove bracket mounting bolts, and then remove bracket from body assembly.
    Fig 2: Identifying Flow Control Valve A, Flow Control Valve Spring, Flow Control Valve B Assembly And Body Assembly
    G05729693Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals