September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Precautions for CAN System
- Do not apply voltage of 7.0V or higher to terminal to be measured.
- Maximum open terminal voltage of tester in use must be less than 7.0V.
- Before checking harnesses, turn ignition switch OFF and disconnect battery negative cable.
- Area to be repaired must be soldered and wrapped with tape. Make sure that fraying of twisted wire is within 110 mm (4.33 in).
Courtesy of NISSAN MOTOR CO., U.S.A.
- Do not make a bypass connection to repaired area. (If the circuit is bypassed, characteristics of twisted wire will be lost.)
Courtesy of NISSAN MOTOR CO., U.S.A.