DTC 13: Engine Coolant Temperature (ECT) Sensor
- Check Power Supply I
Turn ignition off and disconnect EFI sub-harness connector No. 2. Turn ignition on. Measure voltage between EFI sub-harness connector No. 2 terminal "d" (Yellow/Black wire) and ground. See Fig 1 and Fig 2 . If voltage is approximately 5 volts, go to next step. If voltage is not as specified, repair harness or connectors as necessary. - Check Ground Circuit I
Turn ignition off. Check EFI sub-harness No. 2 continuity between terminal "a" (Black/Yellow wire, with TCS; Black wire, without TCS) and engine ground. See Fig 3 . If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary. - Check Power Supply II
Connect EFI sub-harness No. 2 connector. Disconnect ECT harness connector. Turn ignition on. Measure voltage between ECT harness connector terminal "h" (Yellow/Black wire) and ground. See Fig 4 and Fig 5 . If voltage is approximately 5 volts, go to next step. If voltage is not as specified, repair harness or connectors as necessary. - Check Ground Circuit II
Turn ignition off. Check ECT harness continuity between terminal "g" (Black wire) and engine ground. See Fig 6 . If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary. - Check Component
Inspect ECT sensor. See I - SYSTEM/COMPONENT TESTS article. Replace ECT sensor if necessary and perform FINAL CHECK .