(Shift Lever Removal And Installation)
ABBREVIATED PROCEDURE
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery (-) terminal | - | - | - | - | - |
| 2 | Remove the shift lever knob & boots pull both up | - | - | - | - | - |
| 3 | Remove the floor console assembly (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ASSEMBLY ") |
- | - | - | - | - |
| 4 | Disconnect the shift lever connector | - | - | - | - | - |
| 5 | Remove the wiring clip | - | - | - | - | - |
| 6 | Remove the shift cable after removing the snap pin | - | - | - | - | - |
| 7 | Remove the shift lever assembly after removing the bolts | Bolt | 8.8 - 13.7 (0.9 - 1.4/6.5 - 10.1) | - | - | - |
|
||||||
| Install in the reverse order of removal | ||||||