LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2022 >> Veloster N Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
    CAUTION:
    • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the diagnostic tool after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the intake manifold. (Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")
  4. Remove the delivery pipe foam (A).
    G15472109Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the rail pressure sensor connector and then remove the sensor (A) from the delivery pipe.
G15472110Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals