Control Circuit Inspection
| Check Item | Specifications | Prerequisite condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Control Circuit - Voltage | Approx. 2~3V |
|
Control terminal of HO2S Heater Harness | Chassis GND |
- Is voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure
NO
- Repair or replace as necessary and Go to "Verification Of Repair " procedure
NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.