LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2021 >> Veloster 2.0, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM (A) with the SRSCM mounting nuts.

    Tightening torque  :

    7.8 - 10.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2lb-ft)

  4. Connect the SRSCM harness connector.
  5. Install the heater ducts and floor console.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  6. Reconnect the battery negative cable.
  7. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then turns off.
scientia non olet · About LEMON Manuals