Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
- Connect GDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
- Clear all DTC in the system with GDS.
- Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
- Monitor "Diagnostic Trouble Codes (DTC)" with GDS and verify that any DTC is stored.
- Are any DTCs stored in the system?
YES
- Go to applicable troubleshooting procedure.
NO
- Problem is corrected and the system operation performs to specification at this time.