Repair Procedures: Installation
- Install in the reverse order of removal.
- Fill with engine coolant.
(Refer to Cooling System - "COOLANT ")
NOTE:
- The coolant must be injected according to the Integrated Thermal Management Module (ITM) coolant filling method.
Perform the following
- Refill the transaxle with fluid.
- Inspect for fuel leakage.
- After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
- Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
- Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.