LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2019 >> Santa Fe SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Installation

WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Install a new front impact sensor.
  2. Tighten the front impact sensor mounting nut.

    Tightening torque: 

    7.8 - 10.8 N.m (0.8 - 1.0 kgf.m, 5.7 - 7.2 lb-ft)

  3. Connect the front impact sensor connector.
  4. Install the radiator assembly.
  5. Reconnect the battery negative cable.
  6. After installing the front impact sensor, confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About LEMON Manuals