[In The Case Of Installing New ECM]
WARNING: This page is about a different variant/trim than selected.
- Perform
"Key teaching" procedure with GDS. Refer to TEACHING PROCEDURES
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
CAUTION:
- When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
- Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
- Install in the reverse order of removal.
ECM Installation nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)