Check Short To Ground In CAN Communication Line
- IG key "OFF".
- Measure resistance between CAN high terminal (#3) of diagnostic connector and chassis ground.
- Measure resistance between CAN low terminal (#11) of diagnostic connector and chassis ground.
Specification: ∞ Ω
- Is the measured value within specification?
YES
- Check PCM, 4WD ECU, TCM and ESC ECM connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.
NO
- Check short to battery in communication line. And then, go to 'Verification of Vehicle Repair " procedure.
- Check short to ground in communication line. And then, go to 'Verification of Vehicle Repair " procedure.