LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2018 >> Santa Fe XL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Remove the floor console.

    (Refer to  FLOOR CONSOLE  ) 

  4. Loosen the bolts and then remove the rear air vent duct (A).
    G12033164Courtesy of HYUNDAI MOTOR AMERICA
  5. Pull up the lock, of the SRSCM connector, then disconnect the connector (A).
    G12033165Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove the SRSCM.
    CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
scientia non olet · About LEMON Manuals