LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2018 >> Ioniq Plug-In Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 53 (Charging Control Module Diagnosis (EV)) >> DTC C1865-00: CAN/PLC Time-Out CCM >> Verification of Repair >> Verification of Vehicle Repair
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Verification of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verify that the fault has been corrected.

  1. Vehicle parked & Ignition switch 'ON'.
  2. After connecting GDS, select "Diagnostic Trouble Codes(DTC)" Analysis mode.
  3. Clear recorded DTC using GDS.
  4. Operate the system within DTC "Enable conditions" in "General information".
  5. After selecting "Diagnostic Trouble Codes(DTC)" mode and check if DTC is recorded again.
  6. Are any DTCs recorded?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System performing to specification at this time.
scientia non olet · About LEMON Manuals