Ground Circuit Inspection
- Turn the ignition switch "OFF".
- Disconnect APS connector.
- Turn the ignition switch "ON" & ENG "OFF".
- Measure voltage between APS1 power terminal of APS harness connector and chassis ground. (Measurement "A")
- Measure voltage between APS1 power and APS1 ground terminals of APS harness connector. (Measurement "B")
Specification: Voltage difference between measurement "A" and "B" is below 200mV
- Is the measured voltage within specification?
YES
- Go to "Component Inspection "
NO
- Repair relevant component (s) as necessary and then go to "Verification of Vehicle Repair "