LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Veloster Turbo, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L T-GDI >> Knock Sensor (KS) >> Repair Procedures >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold.

    (Refer to INTAKE MANIFOLD .)

  3. Disconnect the injector connector (A).
  4. Remove the installation bolt (B), and then remove the sensor from the cylinder block.
    Fig 1: Locating Injector Connector And Installation Bolt
    G12124811Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals