LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Tucson Value, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules And Clock Spring >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Removal

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module by putting in a flat tool (Ø5 mm) into the guide hole and then press the fixed wire.
    Fig 1: Removing Driver Airbag Module
    G12041393Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the horn connector (B).
    Fig 2: Disconnecting Horn Connector
    G12041394Courtesy of HYUNDAI MOTOR AMERICA
  4. Release the connector locking pin, then disconnect the driver airbag module connector (A).
    Fig 3: Disconnecting Driver Airbag Module Connector
    G12041395Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  5. Remove the steering wheel and steering wheel column shroud (A).

    (Refer to Steering System - "STEERING WHEEL " and "MOTOR DRIVEN POWER STEERING ")

    Fig 4: Removing Steering Wheel And Steering Wheel Column Shroud
    G12041396Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the clock spring (A) and horn connector (B), then remove the clock spring.
Fig 5: Disconnecting Clock Spring And Horn Connector
G12041397Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals