Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear hub bearing assembly.
(Refer to Driveshaft and Axle - "REAR HUB/CARRIER ")
Remove the sensor cap (A).

Fig 1: Removing Sensor Cap
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- When removing the sensor cap, remove by hammering the gap between the sensor cap and hub bearing assembly using the scraper (A).
  
  Fig 2: Removing Sensor Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- To widen the gap little by little, hammer around the bearing cap over 10-20 times.
  
  Fig 3: Locating Bearing Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- When using the hammer, be careful not to damage the hub bearing assembly.
  
  Fig 4: Hub Bearing Assembly
  Courtesy of HYUNDAI MOTOR AMERICA
- When alternately tap the gap between the various places with the mallet.
Install the sensor cap (A) with the special service tool (SST No.: 09527-2W100, 09231-H1100).

Fig 5: Installing Sensor Cap
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Before installing the sensor cap, do not let any foreign material and contaminant inside the hub bearing assembly.
  
  Fig 6: Installing Sensor Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- Hammer until there is no gap between the SST and hub bearing assembly and install the sensor cap.
Fig 7: Installing Hub Bearing Assembly (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 8: Installing Hub Bearing Assembly (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA