LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control System Diagnosis >> DTC C1513: Brake Switch Circuit Error >> Component Inspection >> Brake Light Switch Check
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Brake Light Switch Check

  1. IG "OFF".
  2. Disconnect the brake light switch connector.
  3. Measure resistance between power terminal and signal terminal of the brake light switch connector.

    Specification: 

    Resistance between terminals of the brake light switch - ∞Ω(when the plunger is pushed down), 0Ω(when the plunger isn't pushed down)

    Resistance between the terminals of the brake switch - ∞Ω(when the plunger is not pushed down), 0Ω(when the plunger is pushed down)

  4. Is the measured value within specifications?

    YES 

    • Fault is intermittent caused by poor connection in brake light switch harness and/or HECU's connector. Go to Verification Of Vehicle Repair procedure below.

    NO 

    • Substitute with a known-good brake light switch and check for proper operation. If problem is corrected, replace brake light switch and then go to Verification Of Vehicle Repair procedure below.
scientia non olet · About LEMON Manuals