LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Genesis Coupe 3.8, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Audio/Video/Navigation System) >> Front LCD monitor >> Repair procedures >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Repair procedures: Removal

WARNING: This page is about a different car, the 2016 Hyundai Genesis and 2015 Hyundai Genesis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Take care not to scratch the crash pad and related parts.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad side garnish assembly.

    (Refer to "CRASH PAD SIDE GARNISH ASSEMBLY ")

    CAUTION: In case of working on the non-gloss timber trimming, special care shall be given to the following.
    • When removing with the screwdriver or remover, wrap the protective tape on the tools.
    • Be careful not to damage parts because the non-gloss timber trim is easily scratched or picked.
    • Be careful to store and handle the crash pad when removing/installing because lubricant and oil can leave a stain on the trim.
  3. Remove the fascia panel monitor.

    (Refer to "CRASH PAD MAIN LOWER ASSEMBLY ")

  4. Remove the front LCD monitor after loosening the mounting screws.
    Fig 1: Removing Front LCD Monitor Mounting Screws
    G10454033Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals