Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the driveshaft and axle.
(Refer to Driveshaft and axle - "FRONT DRIVESHAFT ")
Remove the propeller shaft (A).
Tightening torque:

49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)

Fig 1: Identifying Propeller Shaft
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the transfer upper & lower mounting bolts. (transfer side → transaxle side)

Fig 2: Identifying Transfer Upper And Lower Mounting Bolts (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Transfer Upper And Lower Mounting Bolts (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the transfer lower mounting blot. (transaxle side → transfer side)

Fig 4: Identifying Transfer Lower Mounting Blot

Courtesy of HYUNDAI MOTOR AMERICA