Shift Lever Assembly Replacement

Remove the floor Interior console assembly.
(Refer to "INTERIOR(CONSOLE) " in BD group)
Remove the cover (A).

Fig 1: Identifying Floor Interior Console Assembly Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 2: Identifying Select Cable And Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 3: Removing Shift Lever Assembly Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing the clip (A).

Fig 4: Identifying Shift Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Identifying Lever
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.