Repair Procedures: Installation

Installation is in the reverse order of removal.

Perform the following:

• Adjust the shift cable.
• Adjust the throttle cable.
• Refill engine with engine oil.
• Refill a transaxle with fluid.
• Refill power steering fluid.
• Refill a radiator and a reservoir tank with engine coolant.
• Place a heater control knob on "HOT" position.
• Clean battery posts and cable terminals and assemble.
• Inspect for fuel leakage.
  • After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
  • Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
• Bleed air from the cooling system.
  • Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
  • Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.