LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2013 >> Accent GLS, Standard Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Manual Transaxle Control System >> Shift Lever >> Repair procedures >> Removal >> Shift Lever Assembly Replacement
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Shift Lever Assembly Replacement

  1. Remove the floor Interior console assembly.

    (Refer to "Interior (CONSOLE )" )

  2. Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.
    Fig 1: Identifying Select Cable Snap Pin
    G08804603Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Removing Clip From Select Cable Assembly
    G08804604Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the clip (A) from the shift cable assembly.
    CAUTION: Set securely.
    Fig 3: Identifying Shift Cable Assembly Clip
    G08804605Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift lever assembly (B) after removing shift lever assembly installation bolts (A-4ea).

    Tightening torque: 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 4: Identifying Shift Lever Assembly And Installation Bolts
    G08804606Courtesy of HYUNDAI MOTOR AMERICA
  5. Installation is the reverse of removal.
    NOTE:
    • Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
scientia non olet · About LEMON Manuals