LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Veracruz GLS, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Immobilizer System Diagnosis >> DTC P1675: Transponder Programming Error >> Scan Tool Diagnostics >> Monitor Scan Tool Data
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Monitor Scan Tool Data

  1. Connect scan tool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF"
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC P1675 present?

    YES

    1. Go to INSPECTION & REPAIR  procedure

    NO

    1. Fault is intermittent caused by poor contact in SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared.

      Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR  procedure.

scientia non olet · About LEMON Manuals