General Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item	Detecting Condition	Possible Cause
DTC Strategy	Signal Voltage Check	Short to battery, short to ground, open or poor contact on Latch Motor circuit Short to battery, short to ground, open or poor contact on Latch Switch circuit Faulty motor Faulty switch Blown fuse Faulty PTM (These troubles may lead the counter direction movement of the trunk lid)
Enable Conditions	IG ON In case of faulty Latch Motor Lock latch mechanically after open trunk → Power Striker Full Down (Lock) → Push the Outside Switch In case of faulty switch Repeat Lock/Unlock by the Emergency handle manually.
Threshold Value	In case of faulty Latch Motor It is disable to unlock latch after Power Striker Shaft Pop up (Unlock) In case of faulty switch There is no signal change of the latch switch (Lock/Unlock) There is no movement of the Power Striker Shaft (Pop Up & Down)
Diagnostic Time	3 times in sequential (Present DTC)
DTC Erasing Time	Erase the present DTC in the moment of Wake-up after Sleep or trouble fixed. (The present DTC → The past DTC)
Limp Home Mode	It is available to operate by hand-operated (Except motor stuck)